Ricoh R10 Bedienerhandbuch PDF herunterladen (Seite 112)

Changing Camera Settings

110

Setting the Information Displayed in Shooting Mode

:PV DBO TFU UIF JOGPSNBUJPO EJTQMBZFE GPS FBDI OVNCFS PG QSFTTFT PG UIF

DISP. button in shooting mode.

1 Select [DISP. Button Display Setting] in the [Setup] menu and

then press the $ button.

The [DISP. Button Display Setting] screen appears.

2 Use the #$ buttons to set [Use DISP.

Screen].

O1 to O3 to indicate the number of but-

ton presses, and OOff indicates the picture

display is off.

3 Use the ADJ. lever to enable or disable

a setting.

A setting without a check mark is disabled (the information is not displayed).

For the setting in the diagram, there are three display patterns for when the

DISP. button is pressed. O1 cannot be disabled.

4 Use the !"#$ buttons to select a display item and then use

the ADJ. lever to turn it ON/OFF.

Graphic Display Displays the values that can be set at the bottom of the screen while the aper-

ture and shutter speed are being changed.

Information Display Displays symbols for the shooting mode, settings, etc.

Grid Guide Displays guidelines for shooting.

4FMFDUUIFUZQFPGHSJEJO<(SJE(VJEF%JTQMBZ0QUJPOT>PGUIF<4FUVQ>NFOV

Level Indicator Displays an indicator for confirming camera tilt.

Histogram Displays a histogram.

5 Press the MENU/OK button.

The [Setup] menu reappears.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 151 152

Keine Kommentare

Ricoh R10 Bedienerhandbuch Seite 112