Ricoh DDP92 Spezifikationen Seite 118
- Seite / 182
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Disassembling, Assembling & Adjustment 6-29
M M L 0 0
6.2.10. Removal of the Rubber, Double Feed Prevention Roller
Applicable jigs and tools: +Screwdriver.
[Disassembling Procedures]
1. Remove the cover A. (Refer to item 6.2.8 on page 6-27)
2. Remove the feed roller unit. (Refer to item 6.2.9 on page 6-28)
3. Remove the 4 set screws, Then remove the plate.
4. Remove the 3 stop rings, then pull out the shaft, and remove the double-feed-pre-
vention roller together with the feed-reverse gear.
5. Remove the rubber from the double-feed-prevention roller.
Figure 6-49. Removal of the Rubber, Double Feed Prevention Roller
[Assembling Procedures]
1. Reinstall the Rubber, Double Feed Prevention Roller reversing the procedure
above.
CAUTION:
Be sure to turn OFF the MAIN AC POWER prior to performing the maintenance.
CAUTION:
Ensure that the mounting direction of the rubber is correct.
- Finisher 1
- Maintenance 1
- NOTICE TO USER 2
- DDP92/184 3
- DDP92/184 Finisher 4
- Maintenance Manual 4
- Revision Table for manual 6
- Contents iii 10
- Chapter 1. Outlines 12
- Amount of paper curl 13
- 5 sheets of printed paper 13
- °C (50 to 89.6 °F) 14
- °F) max 14
- °C (66.2 to 77 °F) 14
- 1.3. Configurations 15
- 3.1. Maintenance Precautions 18
- 3.3. Tool Required 19
- General Information 3-3 20
- General Information 3-5 22
- General Information 3-7 24
- Preventive Maintenance 4-1 36
- Preventive Maintenance 4-3 38
- [Assembling Procedures] 39
- 3. Close the Front Cover 39
- 4.3.3. Replacing the Stapler 42
- Chapter 5. Troubleshooting 46
- 5.1.2. Stapling failure 48
- 6.3.16, 6-50 49
- 6.3.18, 6-54 49
- 6.3.19, 6-56 50
- 6.3.18, 6-54 ) 50
- 6.3.23, 6-61 50
- 5.1.8. Paper order is reserve 51
- 3.5, 3-7 52
- 5.2. Error Code Indication 53
- Troubleshooting 5-9 54
- Troubleshooting 5-11 56
- 3.4, 3-3 57
- 5.2.4. E00D SUB TRAY FULL 58
- 5.2.5. E019 LOW STAPLE (R) 58
- E01A LOW STAPLE (F) 58
- E03F FNS FRONT COVER OPEN 61
- Troubleshooting 5-17 62
- 5.2.9. E1C3 FNS LEAD JAM 6 64
- 5.2.10. E1C4 FNS LEAD JAM 7 64
- 5.2.11. E1C5 FNS LEAD JAM 8 65
- 5.2.12. E1C6 FNS TRAIL JAM 7 65
- Troubleshooting 5-21 66
- 5.2.16. E1D0 FNS LEAD JAM 1 67
- 5.2.17. E1D1 FNS LEAD JAM 2 67
- 5.2.18. E1D2 FNS LEAD JAM 3 68
- 5.2.19. E1D3 FNS LEAD JAM 4 68
- 5.2.20. E1D5 FNS TRAIL JAM 2 69
- 5.2.21. E1D6 FNS TRAIL JAM 3 69
- 5.2.22. E1D7 FNS TRAIL JAM 4 70
- 5.2.23. E1D8 FNS LEAD JAM 5 70
- E1D9 FNS TRAIL JAM 5 70
- E264 FINISHER ACT TIMEOUT 72
- E266 FINISHER DORMANT TIMEOUT 72
- E268 FINISHER BUSY TIMEOUT 72
- E26C FINISHER PRINT TIMEOUT 72
- Troubleshooting 5-29 74
- E2C3 STAPLING F ERROR 75
- E2C4 STAPLING R ERROR 75
- 5.2.29. E2C2 STAPLING ERROR 75
- E2CB STAPLER ROTATE ERROR 2 76
- 6.2.5, 6-21 77
- Figure 5-7 77
- 6.3.12, 6-46 78
- 6.2.1, 6-11 79
- 5.2.34. E2C9 BELT POS. ERROR 80
- 5.2.36. E2E5 FNS DRIVER 82
- Troubleshooting 5-39 84
- Troubleshooting 5-41 86
- 6.1.1. Composition 90
- CAUTION: 100
- M M L 0 0 106
- Stacker/Stapler Unit 106
- 6.2.8. Removal of the Cover A 116
- 6.3. Adjustment 119
- CURRENT DATA 151
- Stapling / Folding position”) 152
- 7.1. Center Cross Section 156
- 7.2. Drive System Diagram 158
- 7.2.1. Paper Conveyance Drive 158
- 7.2.2. Stacker Drive 159
- 7.2.3. Folding Drive 159
- 7.3. Paper Conveyance Path 160
- 7.3.1. Paper Conveyance Path 160
- 7.3.2. Offset Mode 161
- 7.3.3. Non-staple Mode 162
- 7.3.4. Sub-tray Exit Mode 162
- 7.3.5. Staple Mode 163
- Theory of Operation 7-9 164
- 7.3.6. Booklet Mode 165
- 7.4. Conveyance Section 166
- 7.4.1. Construction 166
- 7.4.2. Mechanism 167
- 7.4.2.4. Stacker Unit 168
- Theory of Operation 7-15 170
- Theory of Operation 7-17 172
- 7.5. Stapler Unit 173
- 7.5.1. Composition 173
- 7.5.2. Mechanism 173
- 7.5.2.2. Single Staple (Rear) 174
- 7.5.2.3. Two Staples (Flat) 174
- Theory of Operation 7-21 176
- 7.5.2.6. Stapling operation 177
- 7.6.1. Composition 179
- 7.6.2. Mechanism 180
- SUPPLEMENT 1 (1/1) 182
Verwandte Produkte und Handbücher für Drucken & Scannen Ricoh DDP92
Drucken & Scannen Ricoh LDD735 Wartungshandbuch
(153 Seiten)
(153 Seiten)
Drucken & Scannen Ricoh SP 200 Spezifikationen
(238 Seiten)
(238 Seiten)
Drucken & Scannen Ricoh D012 Bedienungsanleitung
(25 Seiten)
(25 Seiten)
Drucken & Scannen Ricoh SP 1210N Betriebsanweisung
(129 Seiten)
(129 Seiten)
Drucken & Scannen Ricoh G183 Wartungshandbuch
(300 Seiten)
(300 Seiten)
Drucken & Scannen Ricoh 9021d Betriebsanleitung
(76 Seiten)
(76 Seiten)
Drucken & Scannen Ricoh C248 Bedienungsanleitung
(112 Seiten)
(112 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.097 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern