Ricoh Container Stacker Betriebsanweisung

Container StackerUser’s Guide© 2007 Ricoh Corporation5 Dedrick PlaceWest Caldwell, NJ 07006January 2007N905265B

1-21.2 Configuration of Container Stacker*: These figures show a connection of the DDP70 and the standard fi

1-31.3 Component Locations No. Component Description1 Sample tray Holds up to 100 sheets of paper.2

1-4 Container Stacker 1 (including sample tray) Container Stacker 2 (including through path unit )

1-51.4 CoversOpen each cover according to the directions described below.Container Stacker 1 (including samp

1-61.5 Powering on the PrinterThe switch of the power supply "on/off" of the printer is at the pos

1-7PrinterContainerStacker1MaintenanceareaUnit : mm1.6 Installation spaceSpace required for installation of

1-8(2) DDP70/92+Container Stacker 2(through path unit)+Container Stacker 1(sample tray) OG A 03HCFMaintenanc

1-9 (3) DDP70/92+Container Stacker 2(through path unit)+Standard finisherHCFStandard finisherMaintenanc

1-10(4) DDP184+Container Stacker 1(sample tray)OG A 01Unit: mmMaintenanceareaServerContainerStacker 1Printer

1-11(5) DDP184+Container Stacker 2(through path unit)+Container Stacker 1(sample tray)OG A 00Unit: mmMainten

© 2007 Ricoh Corporation. All rights reserved.No part of this document may be reproduced without the expressed permission of RicohCorporation.The mate

1-12(6) DDP184+Container Stacker 2(through path unit)+Standard finisherOG A 00Unit: mmServerMaintenanceareaＨ

2-1Section 2. Preparation for Printing2.1 Summary of this sectionThis section describes the following: Prin

2-22.2 Printer setting2.2.1 Short StackingYou can set the limit of stack amount of the container stacker thr

2-32.2.2 Decurler functionThe Decurler function has three (3) options:AutoSelect = The engine makes the deci

2-4(2) Follow the instructions below in order to get good stacking.a) Check the characteristic of paper

2-52.3 Preparation of stackerPut the basket in the container beforehand. If you start printing without pu

2-64. Load the basket on the drawer unit.[NOTE] • Load the basket in the correct direction. Be sure to l

3-1Section 3. Removal of Paper3.1 Summary of this section This section describes the following: Removal o

3-23.2 Removal of paper3.2.1 ContainerA message “Stacker xxx Full” is displayed on the OCP of the printer wh

3-33. Remove paper from the basket. Do not lift or move too heavy basket to avoid in

Revision Table for manualPageRev.MachineRev.Page No.(Contents) Date00 - First Edition Oct. 200101 - i,Safety-2,1-3,1-4,1-6,2-3,2-4,2-5,3-2,3-3,3-4,4-2

3-43.2.2 Sample tray[NOTE]• The sample tray has no sensor to detect “Paper Full”. Do not stack over 100sh

3-53.3 Removal of paper during printingPress the “OFFLINE/PAUSE” button on the OCP to remove paper during pr

3-6

4-1Section 4. Maintenance4.1 Summary of this sectionThis section describes the following: CleaningOG A 00OG

4-24.2 Cleaning Move the table down to the lowermost position (the lamp is slow blink)and turn off the po

4-3

5-1Section 5. Troubleshooting5.1 Summary of this section This section describes the following: Recovery f

5-25.2 Recovery from paper jam5.2.1 Locations of components and error codesThe components of the container s

5-3Container stacker 1+Container stacker 2 (1) When paper is remained in the container stacker:

5-4Container stacker 2+Standard finisher (1) When paper is remained in the container stacker: (2) Wh

IntroductionThis manual provides essential information to operate the Container Stacker.Carefully read and understand the safety instructions in this

5-55.2.2 Recovery form paper jam• Remove the paper jammed at the paper path 2 and 4 over the container stack

5-6 5. Turn the knob to discharge the jammed paper to the basket. Gently pull the drawer uni

5-7• Remove the paper jammed at the paper path 1 and 3 under the container stackers 1 and 2 according to the

5-8 5. Open the L paper guide A using the paper guide tab and remove the jammed paper. 6. Turn the

5-9• Remove the paper jammed at the paper path 5, 6 and 7 according to the following procedure. 1. Open

5-10 4. Open the U paper guide B using the paper guide tab and remove the jammed paper. 5. Return

5-115.3 Precautions Observe the following precautions when using the container stacker:• Gently push ba

A-1Appendix A. SpecificationsA-1 Specifications of container stackerSpecifications are subject to change without notice. Item SpecificationsPaper siz

A-2OG A 00

Contents Safety Summary... Safety-1Section 1. Summary of

iiBLANKOG A 00

1-1 SAFETY SUMMARY 1. General Safety Guidelines Before operating the machine, read the following in

1-2 SAFETY SUMMARY2. Hazard Warning Statements The following are the hazard warning statements

1-3Section 1. Summary of Container Stacker1.1 Summary of this sectionThis section describes the following: