Ricoh G112 Betriebsanleitung PDF herunterladen (Seite 134)

Making Printer Settings Using the Control Panel

134

❒ If the [HD Format] button is not displayed, the optional hard disk unit is not

properly installed. Reinstall the optional hard disk unit. For details about the

optional hard disk unit, see Setup Guide. If you cannot install it properly

even after attempting reinstallation, contact your sales or service represen-

tative.

Displaying the signal strength

Follow the procedure below to check the IEEE 802.11b (wireless LAN) signal on

the [Maintenance] menu.

A Press the {Menu} key.

The [Menu] screen appears.

B Press the {T} or {U} key to display [Maintenance], and then press the {#

Enter} key.

C Press the {T} or {U} key to display [WL.LAN Signal], and then press the {#

Enter} key.

Check the display for result.

D Press the {Escape} key.

The initial screen appears.

❒ If [WL.LAN Signal] is not displayed, [IEEE 802.11b] has not been selected for

[LAN Type] in [Network Setup] on the [Host Interface] menu. Select [IEEE

802.11b] for [LAN Type], and then check that [WL.LAN Signal] is displayed on

the [Maintenance] menu again.

❒ Signal status can be measured in [Infrastructure] under [Comm. Mode] of the

wireless LAN. If [Ad hoc] or [802.11 Ad hoc] is selected in [Comm. Mode], sig-

nal status cannot be measured. To measure signal status, select [Comm.

Mode] in [Infrastructure] under [IEEE 802.11b] on the [Host Interface] menu.

❒ Every time you press the {# Enter} key, the signal is updated.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 298 299

Keine Kommentare

Ricoh G112 Betriebsanleitung Seite 134