Ricoh Type 480 Bedienungsanleitung PDF herunterladen (Seite 106)

JOB EDITOR

size and number of colors.

The tabs "General" and "Pens" appear only, if you open a HPGL-

or a Calcomp drawing file. The "General" card contains

information about general pen settings (pen source, pen

scaling, filling samples) which you can change in the job editor.

Please read the separate Sections on the pen settings for

Calcomp pens from Page 126 and the HPGL pens from Page

118.

The tab "Pens" informs you of the pen settings. There can also

be two symbols which inform you of the setting status: The red

exclamation marks point out that the pen is used with several

pen sizes and only the last set pen size can be shown. The green

check shows, that a pen is used for the current drawing.

Activate / deactivate entries

By default all entries in a job will be printed. Therefore you find

a marked checkbox in front of every entry. If you want to select

specific entries for printing just select them there.

Add entries

A job usually already contains all the setting entries to be

printed off. However, you may wish to enter another setting

value, because changes were made at the last minute or the

entry was simply forgotten. You can add this entry to the list of

entries, which you can see in the job editor on the left-hand side

page:

RW-480 PLOTBASE 106

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 233 234

Keine Kommentare

Ricoh Type 480 Bedienungsanleitung Seite 106