Ricoh Type 480 Bedienungsanleitung PDF herunterladen (Seite 96)

JOB EDITOR

• Job flag sheet:

The job flag sheet contains information about the print job

and is printed together with the print job. Lots of information

on the job flag sheet depend on the entries in the job editor.

Click on the control box "On" to activate this function in the

job editor.

You can also enter further information in the comments field

below it, however with a maximum length of 50 characters.

Please do not use the following characters: " /n /r.

• Plotter:

This setting cannot be altered. The RW-480 plotter is preset.

• E-mail:

Use of the e-mail function must be switched on in the default

values. In addition you have to set some configurations - see

also chapter "Settings for the Response function".

Here you can instruct the program to automatically send an

e-mail or a message to the user on successful completion of

the print job. To send an e-mail, enter the e-mail address of

the user.

• Sample Print:

If a very extensive job with several sets of copies has been

produced, it can be useful to print off a test print first, so that

you can check the quality of the printouts. After starting the

print job each entry will be printed only once. Then the

printing of this job will be stopped automatically so that you

can check the sample prints for a while.

You can find further information about the sample print on

page 81.

• Output:

The list box contains two different options for the output of

the plot at the plotter: front and rear. It is presetted that the

plot is issued to the front. When selecting an output also

notice your "Page order" setting. It also influences the order

of the print outs in the output. For further information see

"Page order".

• Delete:

If you activate this option, the job is deleted after printed out.

RW-480 PLOTBASE 96

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 233 234

Keine Kommentare

Ricoh Type 480 Bedienungsanleitung Seite 96