Ricoh Remote Communication Gate S Installationsanleitung PDF herunterladen (Seite 56)

6. Click [Next].

• For details about proxy server settings, see p.59 "HTTP Proxy Settings".

Email Initial Settings

Remote Communication Gate S can send notifications by e-mail of events such as printer errors and

discovery of new printers. Configure the SMTP server settings in order to enable Remote Communication

Gate S to send e-mail.

1. Under <SMTP>, enter the SMTP server address, port number, and an e-mail address.

The e-mail address will be used as the sender for e-mails sent from Remote Communication Gate S.

2. Under

<Authentication>, configure the authentication settings for accessing the SMTP server.

3. Enter an e-mail address in [Email address for SMTP server connection test:], and then click

[Perform].

A confirmation e-mail will be sent to the address you entered. Check that the sent e-mail arrives. If it

does, the server settings are correct.

4. Click [Next].

• For details about e-mail server settings, see p.60 "Email Settings".

Device Polling Initial Settings

Remote Communication Gate S periodically polls registered printers in order to obtain their status. You can

configure how frequently Remote Communication Gate S polls printers, and the length of time it waits for

a response.

1. On the [Device Polling Settings] screen, enter the polling interval and polling timeout

settings.

2. Under <Excluded IP Address>, specify any IP address ranges you want to exclude from

polling.

3. Click [Next].

• The "polling interval" is the time between the conclusion of the previous status polling and the start of

the next.

• For details about status polling settings, see p.69 "Status Polling".

3. Settings

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 415 416

Keine Kommentare

Ricoh Remote Communication Gate S Installationsanleitung Seite 56